Skip to content
Welland Plumbing and Drain
The Clarence Street lift bridge over the Welland Canal in Port Colborne.

Plumbing in Port Colborne

Which pipe runs under your Port Colborne house?

In Port Colborne, the water supply, the sewer or septic system and the local grant rules shape every plumbing job. Welland Plumbing and Drain identifies the pipe, tests it and writes the price down before work starts.

What do Port Colborne houses have in the ground?

Port Colborne draws its drinking water from its own Niagara Region plant, separate from Welland's, and the City offers a grant for keeping weeping tile, downspouts and sump discharge out of the wastewater system. Welland Plumbing and Drain handles the disconnection and backflow device the grant covers, and the scale that the local water leaves in water heaters.

Port Colborne's water comes from a separate treatment plant, and the City offers a grant to keep groundwater and roof water out of the wastewater sewer.

What does the Port Colborne grant pay toward?

The City of Port Colborne offers a grant to residential owners who receive a water/wastewater bill. It goes toward four kinds of work:

  • Disconnecting foundation drains. These are the weeping tile: perforated pipe laid along the footing to collect groundwater.
  • Disconnecting downspouts from the wastewater system.
  • Disconnecting sump pump connections that discharge into the wastewater system.
  • Installing a sewage backflow prevention device, such as a backwater valve.

The City requires the work to be done by tradespeople, not by the homeowner. Work is performed by licensed plumbers (306A Certificate of Qualification). Ask the City for the current grant amount and the application steps before any work is booked.

Why keep weeping tile off the wastewater sewer?

A wastewater (sanitary) sewer is sized for what drains out of sinks, toilets and laundry. Weeping tile tied into it adds groundwater during a storm. When the main fills above its normal level it surcharges, meaning the water rises and pushes back up the house lateral. It comes out at the lowest opening in the house, usually the basement floor drain.

A backwater valve is a flap inside the building drain that closes when flow reverses. Ontario's Building Code, Part 7, Article 7.4.6.4., requires one in new construction where fixtures sit below the adjoining street or below the upstream sanitary manhole cover. Older drains can be fitted with one. See sewer repair and backwater valves.

What gets checked before a disconnection?

The camera result decides the scope, so the checks go in this order.

  • A camera goes down the lateral from a cleanout. It shows where the weeping tile joins and what condition the pipe is in.
  • The new sump pit location is chosen. It needs room for the pit, a discharge line to grade and a power supply. See sump pumps.
  • The building department says whether a permit applies. Under the Building Code Act, 1992, changes to drains generally need one.
  • Before anyone digs outside, a locate is requested through Ontario Dig Authority. Public locates do not mark private lines such as the house's own sewer.

You get the price in writing and approve it before any part is fitted.

What does 127 mg/L mean for a water heater?

Hardness is the amount of dissolved calcium and magnesium in the water, stated in milligrams per litre. Niagara Region's published hardness for the Port Colborne Water Treatment Plant was 127 mg/L, measured Oct. 7, 2026. Heating water drives some of that mineral out as scale. In a tank it settles on the bottom or coats an electric element. Rumbling during heating and slower hot-water recovery are the usual signs.

A water heater visit checks the sediment, the anode rod and the temperature setting. Whatever the setting at the tank, the Building Code limits water at a shower head or into a tub to 49 °C. Gas work is performed by TSSA-certified gas technicians.

What about blockages and burst pipes?

A slow main line that is not tied to rain is a drain cleaning call first. If water is running where it should not, shut the main valve and read the emergency plumber page. For planned work, request a written price.

Communities we serve

  • Dain City
  • Stevensville

Which plumbing services reach Port Colborne?

What do Port Colborne homeowners ask?

Can I install the backwater valve or disconnect the weeping tile myself and still get Port Colborne's grant?

No. Port Colborne's grant requires the work to be done by tradespeople, not by the homeowner. That applies to the weeping tile, downspout and sump disconnections and to the backflow prevention device. Work is performed by licensed plumbers (306A Certificate of Qualification). Confirm the amount and the steps with the City before booking. Changes to drains generally need a building permit, and the building department will say whether yours does. See sewer repair and backwater valves and sump pumps.

Where does Welland's water come from, and how hard is it?

The Welland Water Treatment Plant takes its raw water from Lake Erie by way of the Welland Canal and the Welland Recreational Canal, which is the old Welland Canal. Niagara Region operates the plant. It also serves Pelham and portions of Thorold. The Region's published hardness for the plant was 129 mg/L, measured Oct. 7, 2026. Hardness is dissolved calcium and magnesium. When water is heated, those minerals settle as scale in the tank and on heating elements. If your tank crackles or rumbles as it heats, read water heaters.

Does my older Welland house still have a lead water service?

In French Town, around Empire, Burgar and Cozy streets, older houses typically have a lead or galvanized steel service. Look at the pipe where it enters the basement, before the meter. Lead is dull grey, scratches bright silver with a key, and a magnet will not stick to it. Galvanized steel holds a magnet. Ontario's standard for lead in drinking water is 0.010 mg/L, under Ontario Regulation 169/03. The City of Welland and Niagara Region offer a grant toward replacing a lead service with new copper. The application must be approved before work begins. Apply first, then book plumbing repairs.

All questions

Which nearby towns are covered?

Along with Port Colborne, Welland Plumbing and Drain works in Thorold, Pelham and Niagara Falls.

Is water leaking or backing up in Port Colborne?

Tell us what the water is doing and how old the house is. You get a written price to approve before anything is fitted.